Cart
cload
Checkout Secure
Lifetime Customer Support | Best Online Prices

Questions?

Phone Icon 1-877-242-2792

Open Mon-Thurs: 10am-6pm & Friday's 11-5pm Eastern

How to install a Goal Zero MPPT Charge Controller (With pictures)

By SSK Admin November 29, 2021

How to install a Goal Zero MPPT Charge Controller

In this article, we cover, step-by-step, how to install your Goal Zero MPPT charge controller into your Goal Zero MPPT charge controller into your Yeti. We have included pictures every step of the way to make it super easy for you. You can complete the entire process in less than 10 minutes, and you only need a standard Phillips head screwdriver. Enjoy!

When you open the box, you'll find the MPPT Charge controller, screws, and a user guide. 

The only tool you need to install the MPPT is a standard Philips head screwdriver. A smaller head is better as the screws are rather tiny.

 You will need to take out the six screws that hold down the top panel where you will insert the MPPT.

Once the screws are out, the plastic piece will pop out, revealing the area where you will install the MPPT. 

Once you get the piece out, you will see a positive and negative marking on the Yeti. 

The MPPT cable will fit just above the marking on the photos below. The red is for the positive, and the black is for the negative. The single dangling cord is the data transfer switch. 

 

 

 

Once you insert the cables from the MPPT, you can simply place the MPPT into position.

 

Once the MPPT is in place, the last thing to do is install the four screws that came in the MPPT box.

And there you have it, you're done!  You can now enjoy your super efficiently charging Yeti featuring its new MPPT Charge Controller.


Older Post Newer Post